Resin height vs. part height.

General Composites Discussions Composites Talk
#1

Who infuses with their resin bucket on the floor, part on a table, or resin the same height, or resin bucket higher than their part?

Found out that you can not get a good infusion if the resin bucket is higher than the part, due to pressure differences (Read: Siphoning)

#2

correct :slight_smile:

#3

if You infuse at -1Bar bucket no more than 1meter below part

-1Bar about 14,5psi
1m about 3ft

#4

Gotta remember that a lot of parts are not flat. keep the resin lower than the lowest part of the mold.