CFC BMW S1000RR 1 of 1

General Composites Discussions Showcase
#1

Hey guys, long time no see…was very busy setting up my company… just wanted to say a BIG THANK YOU to all the guys here on the forum…since for the last few years we’re sharing secrets, techniques, ideas and after a lot of testing, failures, reading and gained experienced I reached to a level to make my hobby a full time job!

Now on our subject, I present you the demo bike of my company, our racing BMW S1000RR.
Made via Vac.Infusion blending two different carbon weaves. Textreme Carbon is an amazing looking weave!

#2

Just browsed your site. Nice work keep it up! Love the BMW bike, used to own one before I dropped out of bikes. So just a comment, and this may be a American reading this problem. But when you say -70% weight reduction, I see that as a double negative. I think no one will mistake you for making parts 70% heavier than original, but just a observation.

#3

Looks awesome, nice weave pattern. It’s a heavier frabric wright ? Good luck with your company.

#4

I absolutely love the way you are cutting up the carbon look!!! The different weaves in one part is soooo sick!

#5

probably you’re right about the double negative…I might be the first one offering 70% heavier parts made out of carbon fiber :D:D:D Thanks, for the comments!

#6

Actually textreme weave is only 160gr/sqm and much more “powerfull”. Thanks!

#7

Thanks! doing my best :stuck_out_tongue:

#8

Nice work!!!

#9

Nice work!